联系我们
联系我们
山东先进微智能科技有限公司
张经理:18553169683
翟经理:18553169631
李经理:18553169632
地   址:山东济南黄河大街企业
            创业园8号

钣金与工业铝型材框架的组合

  工业铝型材与钣金件的连接不同于PVC板。PVC板和型材之间的连接直接在板材顶部铣削。钣金零件不一样。

  工业铝型材与钣金件的连接不同于PVC板件。PVC板与型材的连接需要在板上直接钻孔,但钣金件不同。

  在整个框架图的布局和确认后,钣金件需要加工和定制。相关注意事项如下:

  在绘制和确认整个框架图时,钣金件需要定制。连接时,请注意以下几点:

  首先,钣金件加工后的尺寸要符合要求,否则连接时间会大或小,影响整个工期。

  首先,加工后的钣金件的尺寸应符合要求,否则会出现连接处变大或变小,从而影响整个施工工期。

  其次,在加工过程中,应合理加工钣金件四面的每个孔。T型螺栓应沿孔位放入槽内,然后与法兰螺母连接。

  其次,在加工过程中,钣金件每侧的每个孔都要经过适当的加工,使T形螺栓能沿着孔插入槽内,然后用法兰与六角螺母连接。

  The connection of industrial aluminum profiles and sheet metal parts is not like that of PVC plates.The connection between PVC plates and profiles is directly milled on top of the plates.Sheet metal parts are not the same.

  The connection between industrial aluminum profile and sheet metal parts is different from that of PVC sheet.The connection between PVC plate and profile requires direct drilling on the plate,but sheet metal parts are different.

  After the layout and confirmation of the whole frame drawing,the sheet metal parts need to be processed and customized.The points for attention in connection are as follows:

  When drawing and confirming the whole frame drawing,the sheet metal parts need to be customized.When connecting them,pay attention to the following points:

  First,the size of the sheet metal parts after processing should meet the requirements,otherwise the connection time will be large or small,which will affect the whole construction period.

  First of all,the size of the processed sheet metal parts should meet the requirements,otherwise it will appear larger or smaller in connection,thus affecting the whole construction period.

  Second,during processing,each hole on the four sides of the sheet metal part should be processed reasonably.T-bolt should be put into the groove along the hole position,and then connected with the flange nut.

  Secondly,during machining,each hole on each side of the sheet metal part should be properly machined so that the T-bolt can be inserted into the slot along the hole,and then connected with the hexagon nut with flange.



线

×

在线客服

online service

张经理:18553169683
翟经理:18553169631
李经理:18553169632